CONTINUOUSWAVE

From what is seen in Figure 1, the Fishmaster T-Top is not an all-welded structure. The Fishmaster and Styker type tops are certainly not all welded construction. They are made in China and shipped in a couple of boxes for assembly at your location. My impression is that the quality is good, but th...

While not a 2016 190 OUTRAGE, I am in the process of installing a Fishmaster T-Top on my 2000 Outrage 18 [note: corrected length from 18-inches; please do not use single quote or double quote marks to indicate length, as these are often confused and used incorrectly, as was done here]. The shipping ...

The [plastic] fuel tank [in the 2000 OUTRAGE 18] is supported on its bottom by two-inch-wide wide rubber strips, three strips on each side of the sloped bottom, leaving [an air] gap all around the tank. The tank cavity [at the aft end] is not enclosed and is open to the stern of the boat. Water in t...

I have had a 2000 OUTRAGE 18 for [several years], and now I am in the finishing stages of a full refurbishment and re-powering of the OUTRAGE 18. To get to the below-deck fuel tank is relatively easy. The center console must be unbolted and moved out of the way. Because I planned to re-wire all the ...

I have had a 2000 OUTRAGE 18 for [several years]. In my 2000 OUTRAGE 18 the fuel tank was made of plastic; it did not need to be replaced. [More about the fuel tank appears in a separate article in REPAIRS and MODIFICATIONS.] I am happy to talk about anything on a 200 OUTRAGE 18. I'm in Southern Cal...