1984 Revenge Deck Repair
Posted: Tue Sep 12, 2023 3:26 pm
[Author imposed qualifying criterion for allowing replies; sorry, this forum does not impose limitations on who can participate in a thread. Your qualifiying limitations have been removed. All can reply if they have information to share.--Moderator]
[This thread may be seeking advice about repairs to the removable deck molded section that covers the fuel tank cavity on a REVENGE boat of unknown length. Please include the LENGTH of any boat for which you seek advice. Please clearly explain what you are asking about and what is to be seen in the illustrations--Moderator]
Q1: after removing all loose wood, how far down does one go?
I have spots that go to the glass skin.
Some spots [show] the polyester resin that was used.
Below in Figure 2 there appears to be 1/4-fiberglassed-plywood ring around the inspection covers, and it is not even a perfect circle.
Q2: should those be sanded and ground down?
ILLUSTRATIONS
[This thread may be seeking advice about repairs to the removable deck molded section that covers the fuel tank cavity on a REVENGE boat of unknown length. Please include the LENGTH of any boat for which you seek advice. Please clearly explain what you are asking about and what is to be seen in the illustrations--Moderator]
Q1: after removing all loose wood, how far down does one go?
I have spots that go to the glass skin.
Some spots [show] the polyester resin that was used.
Below in Figure 2 there appears to be 1/4-fiberglassed-plywood ring around the inspection covers, and it is not even a perfect circle.
Q2: should those be sanded and ground down?
ILLUSTRATIONS