CONTINUOUSWAVE

pred02

The bow stop assembly seen in Figure 1 is good to use with a Boston Whaler boat.

Thanks Jim, helpful as always.

pred02

Q1: is [the bow stop assembly shown in Figure 1] okay [to use with a Boston Whaler boat]? 22898175-bdad-4171-9a2e-49db97b5ef62.jpeg I bought a local Croatian brand (Berkinovac) boat trailer that is a bunk-type per a Boston Whaler recommendation. The bow [stop] assembly has given away and the manufac...

pred02

[Reviving his thread after almost one year being dormant]

The scuppers [on the 2006 210 VENTURA boat that is the topic of this thread] were replaced in 2025. For our mechanic the replacement of the scuppers was not a difficult job.

pred02

Hi Jim, Thanks for posting. I was able to seal the hole using below the line silicone sealant to prevent ingress as a short stop gap measure. Prior to launching next season, I will get the replacement scupper where the broken part is located. Here is the part - as you see the screws are not to screw...

pred02

Thanks Phil!

pred02

Figures 1 and 2 show a broken scupper valve from my 2006 210 VENTURA. scupperValve.jpg hull.jpg Q1: how serious a threat to the hull foam is a broken scupper on a 2006 210 VENTURA? Q2: is continued use of the boat for a couple more weeks okay? I don't want to cause permanent damage to the boat, but ...

pred02

Hi, We imported a 2006 Ventura 210 to Croatia back in 2011. The boat was registered and passed a technical inspection at the local port authority, however since Croatia joined the EU the technical criteria have changed. Upon the recent inspection it was noted that our Ventura is lacking a fire port....

pred02

Thanks Jim for taking your time to provide a detailed explanation, it is very helpful. The boat has two batteries which are in good condition (load tested by the mechanic) however we have an problem starting the engine when the switch is on 2 (versus on 1). Electrics run fine off the second battery ...

pred02

Q4: are there any warehouses that may have remaining stock that are worth checking? I have used Newwiremarine they were excellent for another panel and Flounder Pounder offer a replica but it is not exactly like OEM. [The need to purchase of a replacement electrical panel] is not urgent. [The defect...

pred02

My mechanic informs me my 210 VENTURA battery switch, PERKO model 8501 needs replacing. Sue Lodel recommended Model 8503 as the replacement for the 8501. I understand that the difference is that the 8503 has the alternator field disconnect. Q1: Is it worth paying extra for the 8503 (its cost about d...

pred02

Q1: what has been your first-hand experience with ordering an electrical panel from Ultra Marine?

Q2: what has been your first-hand experience with ordering an electrical panel from Flounder Pounder Marine?

BACKSTORY
I need to replace an faded electrical panel used on a 2006 210 VENTURA.

pred02

I believe the answer to your inquiry is already given above: Contact Sue at Beacon Marine. I have contacted Sue. There are no Viking T-Bar replacements or covers. You need to replace the whole mechanism not just the cover which makes the job not worthwhile given the way its adhered to the bottom. I...

pred02

Where can I get just the T-bar for a Viking Marine PTL-8 Circular Deck Access plate?

pred02

I found the dimensions.

I am trying to figure out the best option for the panel for the Ventura.

Q: Should I try to recreate this?

Q: What is the matching colour to the panel in the first picture?

Thanks

pred02

The boat is abroad so I do not have access to the measurements to recreate. I called Boston Whaler and Ultra Panel. Neither have a [diagram of the panel layout]. I need the panel layout. [Somewhere the following numbers and letter are presumed to appear] 1453174 PANEL, BW210VT-01 SWITCH RAW/FRESH WA...

pred02

Where can a T-bar for a 6-inch Viking hatch plate in white be purchased?

pred02

Hi, I am looking for a replacement quick release pin for the ski pylon for our Ventura 210. I e-mailed Sue Lodel and she says the replacement is $80. This is the 1 1/4 inch Quick Release Pin that locks the pylon. It is something like this: https://www.fastenal.com/products/details/3297268 Does anyon...

pred02

Recommend a vendor to duplicate the panel shown in Figure 1 below from a 210 VENTURA boat.

: Fig. 1. An electrical switch panel photographed at an oblique angle which prevents making an inference about the dimensions.; panel_.jpg (5.1 KiB) Viewed 12460 times

pred02

Hi,

Not it is not we have I think 10 ft on rode and then its rope after that.

Thanks,

pred02

Give me ideas for adding an anchor windlass to a 210 VENTURA.

: Anchor locker; C15248D5-CA3B-4458-97C0-C798E4C3FDE3.jpeg (142.86 KiB) Viewed 2273 times

My parents are getting old. Where they boat in Croatia the anchor almost gets daily usage. The Ventura 210 did not come with an option for an actor windlass option.

pred02

Thank you. I emailed Sue at Twin City and also emailed Boston Whaler at their general email address. I replaced the 15A fuse with another ETA one--not exact but it works. To replace it we got the push button boot off but when i pit it back on it does not stick. How can I make it stick again? Now tha...

pred02

I found this panel. I believe this panel is not original. It can be customized in many colors.

https://www.fpmarine.com/Boston-Whaler- ... awlive.htm

pred02

I have 2006 Ventura 210. One of the 15-Amperes circuit switches for the live well pump needs to be replaced: what is the part number? Also the panel that says Livewell and Raw Water pump has cracked: tell me where I can find a replacement. I checked the schematic on WHALER.COM, but I had a hard time...

pred02

Does this charger work? It has input AC 120-240V, 50hz, 60hz.

https://www.promariner.com/en/~/media/i ... -49934.pdf

pred02

Hi. I plan to add a two-bank battery charger to our Ventura 210. The rationale for this is we usually end up running for short runs insufficient to have the batteries fully charged. While operating a new entertainment loudspeaker amplifier and other electronics running at anchor we end up running th...

pred02

Sorry. [“Vinyl rails” are] not the rail but are the part around the sides behind driver seat so you dont fall over when fishing.

pred02

The vinyl on our 2006 210 VENTURA is getting old and needs to be replaced, particularly on the seats, the safety rails, and some cousins [cushions].

What is the best source for replacement parts for these vinyl seats, safety rails, and [cushions] for a c.2006 210 VENTURA?

Thanks

pred02

Hi, I am looking to get a JL Marine M10IB5-SG-WH infinite baffle subwoofer and am wondering where is the best place to mount it on my 06 210 Ventura boat. I found the following picture from another Ventura with a fusion amp installed from the front right cubboard. Please let me know if this install ...

pred02

This [information in the thread] is perfect, thank you.

pred02

Hi. I have a 2006 Boston Whaler 210 Ventura. The buttons and clips on our vinyl cushions have come apart. We have the replacement buttons from Boston Whaler, but need a stapler of sorts to get them attached again. Can we buy such a device?

Thanks,

: IMG_2610.JPG (25.65 KiB) Viewed 7562 times

pred02

Hi,
We just commissioned our 210 Ventura for the season and the freshwater shower is not working even when the switch is depressed and light is on. Any clues?
Thanks

pred02

: EDEB02E4-F757-45A0-B987-B54D19FC528C.jpeg (237.3 KiB) Viewed 9028 times

: F6087D5F-FC8A-43C8-9BAE-72A0AB79F312.jpeg (195.64 KiB) Viewed 9028 times

pred02

Thank you, e-mailed them but they do not have anything for our model right now. Any other ideas?

Thanks

pred02

Hi. I want to purchase a Yeti or RTIC-style cooler for a Ventura 210. I am debating if I should get a 20- quart or 45-quart version. Unlike center console boats, a 210 Ventura does not have a natural space to store a cooler. A cooler would be put inside the Port bulkhead cabin. Is there sufficient s...

pred02

Thank you, we ordered the part

pred02

Thanks for the head up on NMEA and Smartcraft. I am in touch with Andy from Veradoclub parts; I need a NMEA-2000 gateway, then another part to form the NMEA network - all of this will cost $500 just to get data into the Garmin. I recently disocvered Vesselview mobile - which can push engine data ont...

pred02

I am looking at Echomap 92sv and GPSMAP 722. Would like 722 as it [has] a nicer screen. However not sure [722] will cover the existing flush mount. Garmin 498 cutout dimensions - 141 x 110mm GPSMap 722 cutout dimensions - 132.5 x 214mm I can get the whole KING StarBoard panel re-made, but that’s add...

pred02

Hi. I plan to replace my venerable Garmin 498 fish finder on our Ventura 210. Like the boat, the Garmin is 2006 vintage and it [is] starting to show signs of age. At first the transducer stopped showing correct depth, and the last few years it had trouble acquiring satellites. I can try to update it...

pred02

Hi. Our 2006 Verado 225 on Ventura 210 has hit 300 hours and we need to get the parts kit for our mechanic. Is [8M0097859] the correct part number?

Thank you

pred02

Hi, Happy New Year. We plan to start replacing some vinyl on our 2006 Boston Whaler Ventura 210 as it is starting to discolor. We also have pink stains that appear an ddisappear on some of the cushions. As some of the items are discontinued--I checked with Sue at Twin Cities andit is prohibitive to ...

pred02

Thanks all. 1. We removed the porta porti without any major difficulties just unscrewed the unit and pipes. There were 2 pipes in the back , one was going to the waste out which is on the port side of the boat. Not sure if our boat had overboard discharge - if it did it would be great as this would ...

pred02

Thanks both for your feedback. If you have a picture of the hinge it would be great so we can discuss with our metal guy in Croatia to see what is possible.

When I remove the toilet do any of the wires/plumbing need to be severed?

Kind regard,

pred02

Hi, We had our 2006 BW Ventura 210 in Croatia for about 7 years, it's been great but we are looking to make a handful of modifications to better adjust it to our needs here. 1. Bow Rail - currently the stainless steel bow rail goes across the bow making it difficult to access without jumping over wh...

pred02

Hi. On our 2006 Boston Whaler Ventura 210, the footing of watertight storage compartment on the port side (where the toilet is) has started to take in water from the front compartment. This is due to the base in which the screws are tied in cannot hold the screws anymore (please see pictures). Is th...

Search found 44 matches