Page 1 of 1
1983 13-footer Cockpit Sump Pump
Posted: Wed Aug 17, 2016 8:54 am
by Kochisp
I'd like to add cockpit sump pump to my 13-foot Boston Whaler boat. It seems many people have done this before, but haven't found too many suggestions for a complete setup that includes a pump and float that would fit in that tiny spot that measures about 3 x 5-inches in front of the lower drain plug. Anyone have specific suggestions on what pump and float to use? Pictures of installation would be appreciated too!
Re: 1983 13-footer Cockpit Sump Pump
Posted: Wed Aug 17, 2016 5:27 pm
by jimh
If space is limited for a cockpit sump pump, perhaps choosing one with an automatic sensing device instead of using an external float switch will give you more space and more options.
I don't have any idea how prevalent electrically-operated cockpit sump pumps are on classic 13-foot Boston Whaler boats. Electrical pumps were not a factory-option on the classic 13-foot boats. A lot of them had pull-start outboard engines and no battery, so there was no electrical power for an electric pump. Compare at
http://continuouswave.com/whaler/refere ... drainTubesWater is quickly "run out" of the boat through open drain tubes once underway. Drain plugs can then be installed to keep the boat dry.
Boston Whaler 13-foot boats do not have any bilge space. They have a double-bottom hull and the interior is sealed and filled with foam. The cockpit has a small sump area to collect water, which can be drained to the sea if the plug is left out.
Re: 1983 13-footer Cockpit Sump Pump
Posted: Wed Aug 31, 2016 12:56 am
by 2wheelDuke
I used to have a Rule 360 in the sump on my 13' but I just manually switched it.
A Rule-a-matic would fit. They check for water every 2 minutes.
Mine's under restoration right now, I'll have to decide on a new pump soon.
Re: 1983 13-footer Cockpit Sump Pump
Posted: Wed Aug 31, 2016 9:00 am
by Oldslowandugly
Re: 1983 13-footer Cockpit Sump Pump
Posted: Sat Sep 03, 2016 9:21 pm
by Pescatore
I don't have a picture, since I just sold the boat , a 1968 13 sport. I used a small bilge pump and a float switch, mounted in the splash well. the pump was mounted in back of the first drain hole. The float was mounted behind that. The float was mounted on a wedge made from mahogany, so it would pick up with less water. I mounted a thru hull on the port side splash well , which was the discharge.