2000 Mercury V6 135-HP: Water Spray from Oil Tank Pressure Line
Posted: Wed May 17, 2017 2:32 pm
Hi everyone. I've recently bought a 2000 Mercury 135HP V6 2.5 (single piece cover) and I'm doing a bit of digging before getting the boat in the water. The alarm was sounding continuously as soon as the ignition was switched on, but I fixed that by loosening the engine oil tank until oil flowed out with the engine running. I did notice that when checking for air pressure from the hose to the remote tank that there is a stream of air pressure, there is also a spray misting of water and moisture, which Is obviously not a good thing to be going toward the oil tank. I've not run the engine for more than a few minutes as the tell tale water isn't that strong.
Do you think [the spray misting of water and moisture going toward the oil tank] could just be condensation?
If [the spray misting of water and moisture going toward the oil tank is] not[ just condensation], how does the air pressure get accumulated?
Is [the accumulation of air pressure caused by] a pump"
Or something internal [in the outboard] engine which could have a rotted out waterway?
Thanks for any help,
Rich
Do you think [the spray misting of water and moisture going toward the oil tank] could just be condensation?
If [the spray misting of water and moisture going toward the oil tank is] not[ just condensation], how does the air pressure get accumulated?
Is [the accumulation of air pressure caused by] a pump"
Or something internal [in the outboard] engine which could have a rotted out waterway?
Thanks for any help,
Rich